INITIALIZE HARDWARE SETUP
The PatchMIX is presently AllSilent
The PatchMIX is presently AllSilent
|
INITIALIZE ALL EXP PEDALS ZOOM ControlONE FCB1010 CALIBRATE ZOOM EXP PEDALS 1.Holddown PEDAL 1 SETTING while Power ON 2.Fully close P1 then STORE 3.Fully open P1 then remove feet then STORE 1.Holddown PEDAL 2 SETTING while Power ON 2.Fully close P2 then STORE 3.Fully open P2 then remove feet then STORE 4.Enable P2 stopper then press STORE 5.Disable P2 stopper then turn P2H fully RIGHT then STORE |
XIOsynth
__________________________________
AA.
XIOsynth#299: TouchPad X Type = NO SPRING > OverWrite
BB. Select XIOsynth patch if other than XHP default is desired
IF XIOsynth BOOTS, PITCHWISE, OUT OF SYNC:
Simply change its Bank one or two times (through the BANK/PAGE buttons just to the right of the display) or, adjust: Xiosynth GLOBALS: Verify Global>Cal Pitch/Mod |
TUNE GUITARS ... ANY STRINGED INSTRUMENTS CALIBRATE FCB1010 EXP PEDALS 1.Holddown FS1+5 while Power ON 2.Fully close EXP.A then UP/ENTER 3.Fully open EXP.A then UP/ENTER 4.Fully close EXP.B then UP/ENTER 5.Fully open EXP.B then UP/ENTER |
